Category: EmComm

Go Box is Progressing…

Got a little work done tonight, getting excited to permanently attach everything and wire it up!  The bottom is a 1U drawer from Amazon.  I will post a complete parts list toward the end of the project.  

3D-Printed 1U Panel for Go-Box

On my new Go-Box, the plan is to have the top 1U slot set up for miscelaneous switches, lights and outlets, so I needed a blank panel to start with.   I also wanted to 3D print it so that I could integrate my callsign.  I quick search on Thingiverse yielded this blank panel, which I …

Continue reading

New project – Portable Go Box.

I have started planning for a new go box for use in Emergency Communications (I am in ARES and CERT) and for Field Day, SOTA, and other outdoor operations.  I have based my plans on a few different boxes seen around the internet.  Here are the key aspects I have settled on: Primary rig – …

Continue reading